Skip to content

Students

Administrators load the school’s students, but you can add students too: from the STUDENTS tab, while building or editing a group, or with Add Student in a session that is still open.

Students walkthroughPlays on Vimeo · 0:15Open on Vimeo →
  1. Open a class from your Assignments list.
  2. Under the class details you see three tabs: SESSIONS, STUDENTS and GROUPS. Tap STUDENTS.

If you can’t see all three tabs, the row can be wider than your screen, so the last tab is cut off at the right edge (for example it reads GRO…). Swipe the row of tabs sideways to bring it into view.

The STUDENTS tab lists the students at the class’s school, with tools to find one quickly. They sit in two rows. In the first row, from left to right:

  • + adds a new student (see below).
  • The sort button (three lines) reverses the order of the list.
  • Search …: type part of a name, for example Em, and the list narrows to the students whose name contains it.

In the second row:

  • Status: choose All, Verified or Unverified.
  • Grades: pick one or more grades to show only those students.
  • The X next to Grades clears only your grade choice. It is grayed out until you have picked a grade.
  • On the browser version, a refresh button at the end of the row reloads the list.

To see everyone again, clear the search field, set Status to All, and tap the X. To refresh the list, pull down on it. If pulling down doesn’t refresh it, go back and open the class again.

Each row shows a round avatar with the student’s initials, then their grade and full name. A small badge on the avatar shows whether the student’s information has been verified: a tick for verified, an exclamation mark for not yet verified.

While the list loads you see a spinner. If the school has no students at all, it reads No students found for this school. with an Add Student button beneath it. If your search or filters match nobody, the list is empty: clear the search, set Status to All and tap the X to bring everyone back.

Tap any student’s row to open their profile. See Student profile.

Students Add, sort, search, Status and Grades.

You can add a student from the STUDENTS tab, or from the group screens. The same form opens everywhere.

  1. Tap the + button.
  2. The Add Student sheet opens, showing your school and district at the top.
  3. Fill in First Name*, Last Name* and Grade*. Fields marked * are required; Middle Name is optional. The grades you can pick depend on your program: a program for older students may offer only grades 9 to 12.
  4. Tap Save.

If a required field is empty, an error appears under it and nothing is saved. Otherwise the sheet closes, a message reads Student “…” added successfully!, and the new student appears in the list with the not-yet-verified badge.

The student joins the school’s student list. Adding them to a group is a separate step: see Student groups.